DIY 3D Snowflake

I love this DIY because its so easy and fun to make! It brings life to any room. The only things you need for this are printing paper (about 6), Scissors, Tape, a Stapler, and some string(yarn). To begin take 1 sheet at a time and fold them into triangles(1st picture below). Then cut off the excess trim of the paper. After you trim the paper fold the triangles in half again. After you fold them cut them on the flap side to the right(shown below). Cut 3 slits in the paper. After you cut the slits unfold the snowflake and it should look like below. Take the first roll and tape it. For the next roll flip the snowflake over and tape it backwards. For the 3rd roll flip it over and then staple it together. For the 4th roll take it and flip it again and then staple hem together. Do this for the next 5 single flakes. Then take them all together and staple them. Then take the sides of all them and staple them. Staple the sides untill it is all complete. Then take the string(yarn) and tie it to the end. All you have left to do is hang it up!

(these images are from a Youtube video)

https://www.youtube.com/watch?v=s7of1MSYHcw